That's where I did a hardness test and it came out at about 50RC.Īlso there are some holes that appear to be imperfections in the top working surface. There is a little black spot on the top working surface near the front edge. I have taped off the measurements in inches hoping someone might be able to tell me approximately how much it weighs, heavy yes I know but I haven't been able to lift it and step onto the bathroom scale. All data are subject to change without notification. It has a coat of black paint on it and I haven't wanted to remove that, wanting to keep it original. 3) Consumption and weights are approximate, weight of guiding depends on type and size of diesel hammer guiding. I would have expected to see a cast in logo on the side or something similar but both sides are just rough cast iron, assumed cast. (Kohlswa A1) 37.5' in length, 13' in height for 900 currently (Kohlswa B31) Without knowing how much it weighs its hard to estimate what kind of weight Im working with. When me > m, the direction of me is toward the anvil while m1 under- goes an. ![]() I haven't been able to find any makers name on it. I found an auction website that has a couple seemingly decent sized anvils: 21' in length, 11' in height for 475 currently. The kinetic energy ( KE ) of the intermediate weight after impact is ( KE2 ). Its hard to put a weight on an anvil from dimensions, though in this case Im sure njanvilman can give you a pretty accurate weight as he owns and runs the fisher anvil museum. I own a fairly good sized anvil that has more nostalgic value to me than monetary but I don't know anything about it and hope that perhaps some of the anvil experts can help. ![]() I was surprised when I read the recently submitted thread " What Steel to Use for Casting an Anvil" that there was so much knowledge and passion regarding anvils amongst the PM group.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |